Personal Care Electronics

Power Mode: USB Charging
See more

Power Mode: USB Charging
See more

Power Mode: USB Charging
See more

Power Mode: Battery Powered
See more
High pressure oxygen injection
No needle pressure injection oxygen 95% pure oxygen and active substances, into the basal layer of the skin, oxygen injection water device is equipped with a special stainless steel injection gun, only close to the skin can be oxygen and nutrients into the deep skin layer. Repair and improve hypoxia caused by uneven skin tone, wrinkles, relaxation and pigmentation, recovery skin, smoking skin and other problems.
Mild spray oxygen
The design of oxygen injection device can spray oxygen with pure oxygen massage and active concentrated ingredients.
#Painless and non-trace non-invasive
Negative oxygen ions are naturally absorbed by the skin, with no needle atomization, and no risk without postoperative repair.
#Deep hydrating
Nanoscale atomization technology, make the water molecules become smaller. Go deep into the base.
#Tender skin
It can quickly moisturize the skin, make the skin moist and full, with makeup and smooth.
#Straight to wrinkle
Close to the skin can inject oxygen and nutrients into the skin, so as to achieve the effect of removing wrinkle and tightening the skin.
#Suppress acne growth
The cuticle is softened, the pores are combed, and the dirt deep in the skin is easier to clean.
#Do not pick the skin quality, suitable for the whole family
Non-invasive beauty tender skin, protect the epidermis layer, suitable for any skin. #Improve skin quality
Top skin cells to replenish enough water, effectively improve the dark yellow, and promote metabolism and cell circulation through vacuum negative pressure.
precautions for use
1. The products used in the spray gun must be water-based products (the products with high
viscosity must be diluted with mineral water.）
2. Spray warm water and alcohol before use (clean the gun inside)
3. After each use, we must inject warm water to clean again, after spraying for a few seconds (to avoid the blockage or leakage caused by product drying)
4. The product should not stay in the spray gun and bottle for a long time, and put as much as
possible (avoid blocking the spray gun or water leakage due to the product condensation)
5. Received machine fully charged in use, red charge, green charge. Can not use it when charging!